-
Development of a novel corrugated polyvinylidene difluoride membrane via improved imprinting technique for membrane distillation
- Back
Document Title
Development of a novel corrugated polyvinylidene difluoride membrane via improved imprinting technique for membrane distillation
Author
Nawi N.I.M.,Bilad M.R.,Zolkhiflee N.,Nordin N.A.H.,Lau W.J.,Narkkun T.,Faungnawakij K.,Arahman N.,Mahlia T.M.I.
Name from Authors Collection
Affiliations
Chemical Engineering Department, Universiti Teknologi PETRONAS, Seri Iskandar, Perak, 32610, Malaysia; Ad Advanced Membrane Technology Research Centre (AMTEC), Universiti Teknologi Malaysia, Skudai, Johor, 81310, Malaysia; Nanomaterials for Energy and Catalysis Laboratory, National Nanotechnology Center (NANOTEC), National Science and Technology Development Agency (NSTDA), 111 Thailand Science Park, Pathum Thani, 12120, Thailand; Department of Chemical Engineering, Universitas Syiah Kuala, Jl. Syeh A Rauf 7, Darussalam, Banda Aceh, 23111, Indonesia; School of Information, Systems and Modelling, Faculty of Engineering and Information Technology, University of Technology, Sydney, NSW 2007, Australia
Type
Article
Source Title
Polymers
ISSN
20734360
Year
2019
Volume
11
Issue
5
Open Access
All Open Access, Gold, Green
Publisher
MDPI AG
DOI
10.3390/polym11050865
Abstract
Membrane distillation (MD) is an attractive technology for desalination, mainly because its performance that is almost independent of feed solute concentration as opposed to the reverse osmosis process. However, its widespread application is still limited by the low water flux, low wetting resistance and high scaling vulnerability. This study focuses on addressing those limitations by developing a novel corrugated polyvinylidene difluoride (PVDF) membrane via an improved imprinting technique for MD. Corrugations on the membrane surface are designed to offer an effective surface area and at the same time act as a turbulence promoter to induce hydrodynamic by reducing temperature polarization. Results show that imprinting of spacer could help to induce surface corrugation. Pore defect could be minimized by employing a dual layer membrane. In short term run experiment, the corrugated membrane shows a flux of 23.1 Lm-2h-1 and a salt rejection of > 99%, higher than the referenced flat membrane (flux of 18.0 Lm-2h_asuf and similar rejection). The flux advantage can be ascribed by the larger effective surface area of the membrane coupled with larger pore size. The flux advantage could be maintained in the long-term operation of 50 h at a value of 8.6 Lm-2h-1. However, the flux performance slightly deteriorates over time mainly due to wetting and scaling. An attempt to overcome this limitation should be a focus of the future study, especially by exploring the role of cross-flow velocity in combination with the corrugated surface in inducing local mixing and enhancing system performance. © 2019 by the authors.
Industrial Classification
Knowledge Taxonomy Level 1
Knowledge Taxonomy Level 2
Knowledge Taxonomy Level 3
Funding Sponsor
Yayasan UTP
License
CC BY
Rights
Author
Publication Source
Scopus